
Article 1 
The Annex to Decision 2006/968/EC is amended in accordance with the Annex to this Decision.
Article 2 
This Decision shall apply from 1 July 2010.
Article 3 
This Decision is addressed to the Member States.
Done at Brussels, 12 May 2010.
For the Commission
John DALLI
Member of the Commission
ANNEX

The Annex is amended as follows:

1.. in Chapter I, points (f) and (g) are deleted;
2.. Chapter II is amended as follows:

((a)) points 1 and 2 are replaced by the following:
'
1. 

((a)) conformance with the ISO standards 11784 and 11785, in accordance with the test procedures specified in point 7 of the ISO standard 24631-1; and
((b)) achievement of minimum performance on reading distance as laid down in point 2, in accordance with the procedures specified in point 7 of the ISO standard 24631-3.

2. 

((a)) transponders applying HDX- technology shall have a minimum activating magnetic field strength less than or equal to 1,2 A/m, as measured according to the ISO standard 24631-3, part 7.6.5 “Minimal activating magnetic field strength in HDX mode” and shall develop a modulation amplitude equivalent to 10 mV as measured according to the ISO standard 24631-3, part 7.6.7 “Modulation amplitude in HDX mode” at a magnetic field strength less than or equal to 1,2 A/m;
((b)) transponders applying FDX-B technology shall have a minimum activating magnetic field strength less than or equal to 1,2 A/m, as measured according to the ISO standard 24631-3, part 7.6.4 “Minimum activating magnetic field strength in FDX-B mode” and shall develop a modulation amplitude equivalent to 10 mV as measured according to the ISO standard 24631-3, part 7.6.6 “Modulation amplitude in FDX-B mode”, at a magnetic field strength less than or equal to 1,2 A/m.
'
((b)) the following point 6 is added:
'
6. Approvals granted by the competent authority until 30 June 2010 for identifiers which are tested in accordance with the methods for approval of identifiers applicable until that date shall continue to be valid.
'
3.. Chapters III and IV are replaced by the following:
'
CHAPTER III 
If needed in order to ensure the correct reading of identifiers under local geographic, climatic and/or management conditions, the competent authority may impose specific performance criteria on readers that are used in a specific holding or in a specific type of holding. The management conditions that justify such specific performance criteria are likely to prevail in holdings that handle a high throughput of animals marked with identifiers applying the HDX and FDX-B technology and/or holdings where synchronisation of readers is required according to point 7.7.3 of the ISO standard 24631-2.

CHAPTER IV 
The tests specified in points 1-4 of Chapter II shall be carried out in test laboratories that operate and are assessed and accredited for those tests in accordance with the standard EN ISO/IEC 17025 on “General requirements for the competence of testing and calibration laboratories”. Manufacturers for identifiers that apply for the tests may freely choose between accredited test laboratories.
'
