
Article 1 
Annex II to Regulation (EU) No 510/2011 is amended in accordance with the Annex to this Regulation.
Article 2 
This Regulation shall enter into force on the twentieth day following that of its publication in the Official Journal of the European Union.
This Regulation shall be binding in its entirety and directly applicable in all Member States.Done at Brussels, 17 February 2014.
For the Commission
The President
José Manuel BARROSO
ANNEX

Annex II to Regulation (EU) No 510/2011 is amended as follows:

((1)) Part A is amended as follows:

((a)) point 1 is replaced by the following:
'
1.  1.1. 
In the case of EC type-approved complete vehicles registered as N1, Member States shall, for each calendar year, record the following detailed data for each new light commercial vehicle the first time that it is registered in their territory:


((a)) the manufacturer;
((b)) the type-approval number with its extension;
((c)) the type, variant, and version;
((d)) make;
((e)) category of vehicle type-approved;
((f)) category of vehicle registered;
((g)) the specific emissions of CO2;
((h)) mass in running order;
((i)) technically permissible maximum laden mass;
((j)) footprint: the wheel base, the track width steering axle and the track width other axle;
((k)) the fuel type and fuel mode;
((l)) engine capacity;
((m)) electric energy consumption;
((n)) code of the innovative technology or group of innovative technologies and the CO2 emissions reduction due to that technology;
((o)) the vehicle identification number.

The format set out in Section 2 of Part C shall be used.
 1.2. 
In the case of multi-stage vehicles registered as N1 vehicles, Member States shall, for each calendar year, record the following detailed data with regard to:


((a)) the base (incomplete) vehicle: the data specified in points (a), (b), (c), (d), (e), (g), (h), (i), (n) and (o) of point 1.1, or, instead of the data specified in (h) and (i), the default added mass provided as part of the type-approval information specified in point 2.17.2 of Annex I to Directive 2007/46/EC;
((b)) the base (complete) vehicle: the data specified in points (a), (b), (c), (d), (e), (g), (h), (i), (n) and (o) of point 1.1;
((c)) the completed vehicle: the data specified in points (a), (f), (g), (h), (j), (k), (l), (m) and (o) specified in point 1.1.

Where any of the data referred to in points (a) and (b) of this point cannot be provided for the base vehicle, the Member State shall provide data with regard to the completed vehicle instead.

The format set out in Section 2 of Part C shall be used for completed N1 vehicles.

The vehicle identification number referred to in point (o) of point 1.1 shall not be made public
';
((b)) point 3 is replaced by the following:
'
3. 

((a)) the sources used for the collection of the detailed data referred to in point 1;
((b)) the total number of new registrations of new light commercial vehicles subject to EC type-approval;
((c)) the total number of new registrations of new light commercial vehicles subject to multi-stage type-approval, where available;
((d)) the total number of new registrations of new individually approved light commercial vehicles;
((e)) the total number of new registrations of new light commercial vehicles approved nationally in small series.
';
((2)) Part B is amended as follows:

((a)) the introductory part and point 1 are amended as follows:
'
B. 
Monitoring information which Member States are required to determine in accordance with points 1 and 3 of Part A of this Annex shall be determined in accordance with the methodology in this Part.
 1. 
Member States shall determine the number of new light commercial vehicles registered within their territory in the respective monitoring year divided into vehicles subject to EC type-approval, individual approvals and national approvals of small series and, where available, the number of multi-stage vehicles.
';
((b)) point 4 is deleted;
((c)) in point 7, the following subparagraph is added:
'Notwithstanding that the default added mass shall be taken for Part C of this Annex, where that mass value cannot be determined, the mass in running order of the completed vehicle may be used for the provisional calculation of the specific emissions target referred to in Article 8(4).Where the base vehicle is a complete vehicle, the mass in running order of that vehicle shall be used for the calculation of the specific emissions target. However, where that mass value cannot be determined, the mass in running order of the completed vehicle may be used for the provisional calculation of the specific emissions target.';
((3)) Part C is replaced by the following:
'
C. 
For each year, Member States shall report the information specified in points 1 and 3 of Part A in the following format:


Member State 
Year 
Data source 
Total number of new registrations of new light commercial vehicles subject to EC type-approval 
Total number of new registrations of individually approved new light commercial vehicles 
Total number of new registrations of new light commercial vehicles approved as national small series 
Total number of new registrations of new light commercial vehicles subject to multi-stage type-approval (where available) 



Reference to Section 1.1 of Part A Detailed data per vehicle registered
(a) Manufacturer name EU standard denomination
Manufacturer name OEM declarationCOMPLETE VEHICLE/BASE VEHICLE
Manufacturer name OEM declarationCOMPLETED VEHICLE
Manufacturer name in Member State registry
(b) Type-approval number and its extension
(c) Type
Variant
Version
(d) Make
(e) Category of vehicle type-approved
(f) Category of vehicle registered
(g) Specific CO2 emissions
(h) Mass in running orderBASE VEHICLE
Mass in running orderCOMPLETED VEHICLE/COMPLETE VEHICLE
(i) Technically permissible maximum laden mass
(j) Wheel base
Axle width steering axle (Axle 1)
Axle width other axle (Axle 2)
(k) Fuel type
Fuel mode
(l) Engine capacity (cm3)
(m) Electric energy consumption (Wh/km)
(n) Code of the innovative technology or group of innovative technologies
Emission reduction through innovative technology(ies)
(o) Vehicle identification number
Point 2.17.2 of Annex I to Directive 2007/46/EC Default added mass (where applicable in the case of multi-stage vehicles)





'.
