
Article 1 
Regulation (EC) No 92/2005 is amended as follows:

1.. Article 2 is replaced by the following:
'
Article 2 

1. The following processes are approved and may be authorised by the competent authority for the treatment and use or disposal of Category 2 or 3 material:
(a) alkaline hydrolysis process as defined in Annex I;
(b) high pressure high temperature hydrolysis process as defined in Annex II;
(c) high pressure hydrolysis biogas process as defined in Annex III;
(d) biodiesel production process as defined in Annex IV;
(e) Brookes gasification process as defined in Annex V; and
(f) combustion of animal fat in a thermal boiler process as defined in Annex VI.The process of thermo-mechanical biofuel production as defined in Annex VII is approved and may be authorised by the competent authority for the treatment and disposal of manure and digestive tract content and Category 3 material.
2. The competent authority may authorise the use of other process parameters, on condition that such parameters provide for an equivalent reduction of risks for public and animal health, for the stages of:
(a) the biodiesel production process as defined in Annex IV, point 1(b)(i); and
(b) the process of combustion of animal fat in a thermal boiler as defined in Annex VI, point 1(c)(i).';
2.. in the title and in the first sentence of Article 3, ‘Annexes I to VI’ is replaced by ‘the Annexes’;
3.. Article 4 is amended as follows:

((a)) in paragraph 2, the following subparagraph is added:
'However, material resulting from the biodiesel production process as defined in Annex IV shall be combusted.';
((b)) in paragraph 3, the following point (d) is added:
'
((d)) in the case of material resulting from the biodiesel production process as defined in Annex IV, used for the production of technical products.';
((c)) paragraph 5 is deleted;
4.. the Annexes are amended in accordance with the Annex to this Regulation.
Article 2 
This Regulation shall enter into force on the third day following its publication in the Official Journal of the European Union.
This Regulation shall be binding in its entirety and directly applicable in all Member States.Done at Brussels, 14 November 2006.
For the Commission
Markos KYPRIANOU
Member of the Commission
ANNEX

The Annexes to Regulation (EC) No 92/2005 are amended as follows:

1.. in Annex IV, point 3 is deleted;
2.. the following Annex VII is added:

ANNEX VII 
Thermo-mechanical biofuel production means treatment of animal by-products under the following conditions:


1.. The animal by-products are loaded into a converter and subsequently treated at a temperature of 80 °C for a period of eight hours. During this period, the material is constantly reduced in size using appropriate mechanical abrasion equipment.
2.. The material is subsequently treated to a temperature of 100 °C for at least two hours.
3.. The particle size of the resulting material must not be larger than 20 millimetres.
4.. The animal by-products are treated in such a manner that the time-temperature requirements laid down in paragraphs 1 and 2 are achieved at the same time.
5.. During the heat treatment of the material, evaporated water is continually extracted from the air-space above the biofuel and is passed through a stainless steel condenser. The condensate is kept at a temperature of at least 70 °C for at least one hour before being discharged as waste water.
6.. After the heat treatment of the material, the resulting biofuel from the converter is then discharged and automatically conveyed by a fully covered and interlocked conveyor to incineration or co-incineration on the same site.
7.. A system of hazard analysis and critical control points is in place and maintained which allows for the control of the requirements laid down in paragraphs 1 to 6.
8.. The process is carried out in a batch mode.

