
Article 1 
Annex II to Directive 70/221/EEC is amended in accordance with the Annex to this Directive.
Article 2 

1. With effect from 11 September 2007, if the requirements laid down in Directive 70/221/EEC, as amended by this Directive, are not complied with, a Member State, on grounds related to rear underrun protection:
(a) shall refuse to grant EC type-approval or national type-approval of a type of vehicle;
(b) shall refuse to grant EC type-approval or national type-approval of a rear underrun protection device, as a separate technical unit,
2. With effect from 11 March 2010, if the requirements laid down in Directive 70/221/EEC, as amended by this Directive, are not complied with, a Member State, on grounds related to rear underrun protection:
(a) shall refuse the registration or prohibit the sale or entry into service of new vehicles;
(b) shall prohibit the sale or entry into service of a rear underrun protection device, as a separate technical unit.
Article 3 

1. Member States shall adopt and publish, before 11 March 2007 at the latest, the laws, regulations and administrative provisions necessary to comply with this Directive. They shall forthwith communicate to the Commission the text of those provisions and a correlation table between those provisions and this Directive.They shall apply those provisions from 11 March 2007.When Member States adopt those provisions, they shall contain a reference to this Directive or be accompanied by such a reference on the occasion of their official publication. Member States shall determine how such reference is to be made.
2. Member States shall communicate to the Commission the text of the main provisions of national law which they adopt in the field covered by this Directive.
Article 4 
This Directive shall enter into force on the 20th day following its publication in the Official Journal of the European Union.
Article 5 
This Directive is addressed to the Member States.
Done at Brussels, 17 February 2006.
For the Commission
Günter VERHEUGEN
Vice-President
ANNEX

Annex II to Directive 70/221/EEC is amended as follows:

1.. the following section 5.1a is inserted:
'
5.1a. 

— it must be at rest on a level, flat, rigid and smooth surface,
— the front wheels must be in the straight-ahead position,
— tyres must be inflated to the pressure recommended by the vehicle manufacturer,
— the vehicle may, if necessary to achieve the test forces required, be restrained by any method specified by the vehicle manufacturer,
— if the vehicle is equipped with hydropneumatic, hydraulic or pneumatic suspension or a device for automatic levelling according to load, it must be tested with the suspension or device in the normal running condition specified by the manufacturer.
';
2.. point 5.4.5.2 is replaced by the following:
'
5.4.5.2. A horizontal force corresponding to 25 % of the maximum technically permissible mass of the vehicle but not exceeding 5 × 104N must be applied successively to both points P1 and to point P3;
'
3.. the following section 5.4a is inserted:
'
5.4a. 

5.4a.1. the lateral distance between the fitting elements of the underrun device and the elements of the platform lift, which make the interruption necessary, may amount to no more than 2,5 cm;
5.4a.2. the individual elements of the underrun protection device must, in each case, have an effective surface area of at least 350 cm2;
5.4a.3. the individual elements of the underrun protection device must be of sufficient dimensions to comply with the requirements of paragraph 5.4.5.1, whereby the relative positions of the test points are determined. If the points P1 are located within the interruption area mentioned in 5.4a, the points P1 to be used will be located in the middle of any lateral section of the rear underrun protection device;
5.4a.4. for the area of interruption of the underrun device and for the purposes of the platform lift, point 5.4.1. need not apply.
'
