
Article 1 
Annex III to Decision 97/808/EC is amended as set out in the Annex to this Decision.
Article 2 
This Decision is addressed to the Member States.
Done at Brussels, 1 March 2006.
For the Commission
Günter VERHEUGEN
Vice-President
ANNEX

In Annex III to Decision 97/808/EC the table and the text relating to product family ‘FLOORINGS (2/2)’, are replaced by the following:
'
For the products and intended uses listed below, CEN/CENELEC are requested to specify the following systems of attestation of conformity in the relevant harmonised standards:


Products Intended uses Levels or classes Reaction to fire Attestation of conformity systems
 (A) 
Paving units, tiles mosaics, parquet, decking of mesh or sheet, floor gratings, rigid laminated floorings, wood based products
 (B) 
Raised access floors, cavity floors
 For internal uses including enclosed public transport premises A1FL — A2FL — BFL — CFL 1
A1FL — A2FL — BFL — CFL — DFL — EFL 3
(A1FL to EFL), FFL 4

Homogenous and heterogeneous resilient floor coverings supplied either in tile, sheet or roll form (textile floor covering including tiles; plastic and rubber sheets (aminoplastic thermosetting floorings); linoleum and cork; anti-static sheet; floor loose laid tiles; resilient laminated floorings)
 For internal uses A1FL — A2FL — BFL — CFL 1
A1FL — A2FL — BFL — CFL — DFL — EFL 3
(A1FL to EFL), FFL 4

Homogenous and heterogeneous resilient floor coverings supplied either in tile, sheet or roll form (textile floor covering including tiles; plastic and rubber sheets (aminoplastic thermosetting floorings); linoleum and cork; anti-static sheet; floor loose laid tiles; resilient laminated floorings)
 For external uses — 4
Floor screed materials For internal uses A1FL — A2FL — BFL — CFL 1
A1FL — A2FL — BFL — CFL — DFL — EFL 3
(A1FL to EFL), FFL 4
For external uses — 4







The specification for the system should be such that it can be implemented even where performance does not need to be determined for a certain characteristic, because at least one Member State has no legal requirement at all for such characteristic (see Article 2(1) of Directive 89/106/EEC and, where applicable, clause 1.2.3 of the Interpretative Documents). In those cases the verification of such characteristic must not be imposed on the manufacturer if he does nor wish to declare the performance of the product in that respect.
'
