
1 
These Regulations may be cited as the Road Vehicles (Construction and Use) (Amendment) (No. 2) Regulations 2003 and shall come into force on 1st August 2003.
2 
The Road Vehicles (Construction and Use) Regulations 1986 shall be further amended in accordance with the following provisions of these Regulations.
3 

(1) Regulation 40 shall be amended as follows.
(2) In paragraph (2)—
(a) for the words “A vehicle which is” there shall be substituted “Subject to paragraph (2A), a vehicle which is”; and
(b) after “Schedule 5” there shall be inserted “or with ECE Regulation 67 or 67.01”.
(3) After paragraph (2) of regulation 40, there shall be inserted the following paragraph—“
(2A) A vehicle which first used gas as a fuel for its propulsion on or after 13th November 1999 shall comply with the provisions of Schedule 5 or ECE Regulation 67.01”.
4 
In Table II after item 22, there shall be inserted the following items—“
22A 67 67 27.04.90 Vehicles using liquefied petroleum gas — — —
22B 67.01 67 13.11.99 Vehicles using liquefied petroleum gas — — —”
5 

(1) Schedule 5 shall be amended as follows.
(2) In paragraph 1, after the definition of “double-check valve” the following definition shall be inserted—“
 “electrically operated valve” means a device which is electrically operated and opens when the ignition is switched on and closes when the ignition is switched off or the power is otherwise cut off;”.
(3) For paragraph 4(4), there shall be substituted—“
(4) Flexible hose may be used in a high pressure pipeline either if—
(a) 
(i) it is reinforced either by stainless steel wire braid or by textile braid,
(ii) its length does not exceed 500mm, and
(iii) save in the case of a pipeline attached to a gas container for the purpose of filling that container the flexibility which it provides is necessary for the construction or operation of the gas system of which it forms a part, or
(b) its length exceeds 500mm and it complies with Annex 8 of ECE Regulation 67.01 and is approved and marked in accordance with that Regulation.
(4A) In the case of a motor vehicle which first used gas as a fuel for its propulsion on or after 1st January 2004 a flexible hose of any length used in a high pressure pipe line shall comply with the requirements of Annex 8 of ECE Regulation 67.01 shall be approved and marked in accordance with that Regulation and shall be no longer than is reasonably necessary.”.
(4) For paragraph 8(2) there shall be substituted—“
(2) Where a fixed gas container supplies no gas system other than a gas propulsion system—
(a) an electrically operated valve may be fitted in place of the valve or cock referred to in sub-paragraph (1) above; and
(b) either—
(i) it shall be fitted as near as practicable to the gas container; or
(ii) if fitted in addition to the valve or cock referred to in sub-paragraph (1) above it shall either be incorporated into that valve or cock or be fitted immediately downstream from it; and
(c) it shall if fitted inside the vehicle be so arranged as to prevent as far as is practicable the possibility of gas entering the engine, passenger or living compartments due to leaks, and the space containing the valve shall be so ventilated and drained as to prevent the accumulation of gas in that space.”.
6 
In Schedule 7B, in paragraph 7, for sub-paragraph (b) there shall be substituted the following sub-paragraph—“
(b) “the emissions publication” is the publication entitled “In-Service Exhaust Emission Standards for Road Vehicles—Ninth Edition” (ISBN 0-9526457-8-5) published by the Department for Transport.”.
Signed by authority of the Secretary of State
David Jamieson
Parliamentary Under-Secretary of State,
Department for Transport
4th July 2003