
1 
These Regulations may be cited as the Wireless Telegraphy (Short Range Devices) (Exemption) (Amendment) Regulations 1994 and shall come into force on1st October 1994.
2 
In these Regulations “the Principal Regulations” means the Wireless Telegraphy (Short Range Devices) (Exemption) Regulations 1993.
3 
In regulation 3 of the Principal Regulations—
(a)  after the word “Regulations” in line 1 there shall be inserted the words “unless the context otherwise requires”;
(b)  after the definition of “authorised person” there shall be inserted the following—“
 “direct sequence spread spectrum modulation” means a form of modulation where a combination of data to be transmitted and a known code sequence (chip sequence) is used to directly modulate a carrier;”;
(c)  after the definition of “field strength” there shall be inserted the following—“
 “frequency hopping spread spectrum modulation” means a technique in which the transmitted signal occupies a number of frequencies in time, each for some period of time;”; and
(d)  after the definition of “mW” there shall be inserted the following—“
 “public telecommunication system” shall be construed in accordance with section 9(1) of the Telecommunications Act 1984;”.
4 
For regulation 4 of the Principal Regulations there shall be substituted the following—“
4 

(1) Subject to paragraph (2) below and regulation 5, the establishment, installation and use of any relevant short range device are hereby exempted from the provisions of section 1(1) of the Wireless Telegraphy Act 1949.
(2) The exemption in paragraph (1) above shall not apply to any relevant short range device of a description set out in paragraph 14 of the Schedule hereto forming part of a public telecommunication system.”
5 
In the Schedule to the Principal Regulations—
(a)  for paragraph 4 there shall be substituted the following—“
4 
Wireless telegraphy apparatus designed or adapted—
(a)  for the transmission of non-verbal signals to wireless telegraphy receiving apparatus installed in or upon a building or vessel in order to activate an alarm; and
(b)  so as to be capable of use only on one of the frequencies and at a power not exceeding the maximum for such frequencies specified in the table below—

Frequencies Maximum power erp
161.275 MHz 10 mW
173.225 MHz 10 mW
458.825 MHz 100 mW”;
(b)  paragraph 8 shall be deleted;
(c)  for paragraph 9 there shall be substituted the following—“
9 
Wireless telegraphy apparatus designed or adapted—
(a)  for the transmission of non-verbal signals to wireless telegraphy receiving apparatus giving warning that the animal, object or person to which the wireless telegraphy transmitting apparatus is attached or located in or upon requires attention or is being interfered with; and
(b)  so as to be capable of use only on one of the frequencies and at a power not exceeding the maximum for such frequencies, specified in the table below—

Frequencies Maximum power erp
161.275 MHz 10 mW
173.1875 MHz 10 mW
458.8375 MHz 100 mW”; and
(d)  for paragraph 14 there shall be substituted the following—“
14 
Wireless telegraphy apparatus designed or adapted—
(a)  for the provision of short range data links; and
(b)  so as to be capable of use only within the frequency bands and at a power not exceeding the maximum for such frequency bands, for each category of apparatus, specified in the table below—

Category Description of apparatus Frequencies Maximum power eirp
1 Apparatus designed solely for use  within one  building 2.445-2.455 GHz 100 mW
2 Apparatus designed solely for use  within one building 10.675-10.699 GHz 1 W
3 Wideband Wireless Data Systems  designed for indoor and/or outdoor use using frequency hopping  spread spectrum  modulation 2.4-2.4835 GHz 100 mW (Spectral power density 100 mW/ 100 kHz)
4 Wideband Wireless Data Systems designed for indoor and/or outdoor use using direct sequence spread spectrum modulation 2.4-2.4835 GHz 100 mW (Spectral power density 10 mW/MHz)”
Ian Taylor
Parliamentary Under-Secretary of State
Department of Trade and Industry
31st August 1994